Canon PowerShot A310 Software User's Manual page 6

Chapter 1
Try It! ImageBrowser
Starting ImageBrowser with Mac OS 9
■
Starting ImageBrowser by connecting a camera to
your computer
This is the method in which ImageBrowser is started by
connecting the camera to the computer and preparing it for
communication.
IMPORTANT
• This method can only be used when the camera is connected to
the computer with an interface cable. The program may not
start automatically with some camera models.
• If you are using a memory card reader, refer to the Starting
from the ImageBrowser Icon section of the Starting
ImageBrowser (5/5) topic.
REFERENCE
• To stop ImageBrowser from starting automatically, refer to the
Preventing ImageBrowser from Starting Automatically (Mac OS
9 Only) topic of the Appendices.
6
ImageBrowser Software User Guide
Starting ImageBrowser (3/5)
1.
Use the interface cable to connect the camera to the
computer.
Please see the manual supplied with your camera for
connection instructions.
Some models cannot connect with the computer unless you set
them to a particular mode, such as the Playback mode. As
described in the guides for these models, set the camera to the
correct mode to transfer data.
The ImageBrowser Automation Wizard dialog will appear the
first time you start ImageBrowser.
This dialog allows you to select the next action for
ImageBrowser to automatically perform after it is started.
See the Troubleshooting topic in the Appendices if a dialog like
the ImageBrowser Automation Wizard fails to appear.