HP D7171A - NetServer - LPr Installation Manual page 14

Chapter 2
To prevent the rack from rolling while you mount the HP
NetServer LT 6000r, make sure that the leveler screws (if
any) on the rack's lower four corners are in firm contact with
the floor.
1. Fully extend each of the slide members. The slides lock into position. You
cannot push the slides back in the rack without pressing each slide's release
latch.
2. With the help of at least one other person, lift the server by its four handles.
3. Position the server directly over the extended slides. The arrows on the sides
of the HP NetServer must line up with the slide's mounting hooks before you
lower the server onto the slides. These hooks fit inside of the server as you
lower it onto the slides.
10
Prepare the HP NetServer for Rack Mounting
Mount the Server
Slide
Members