Remove The Bezel Adapters; Remove The Bezel - HP D7171A - NetServer - LPr Installation Manual

Chapter 2
1. Loosen the adjustment knob on one side, insert the rear rack pins into the
holes you marked on the outside rear column, and hold them in position.
2. While holding the slide in the rack, pull out the front bracket to the outside
front column using the grip on the slide; insert the front pins into the marked
hole.
3. With both sets of rack pins in position, release the slide so that the tension
spring seats the slide in the rack. Make sure the pins are seated in the square
holes.
4. Tighten the adjustment knob so that the slide is secure, and will not unseat
itself when mounting the HP NetServer on the slides.
5. Repeat steps 1 through 4 on the other side.

Remove the Bezel Adapters

The HP NetServer LT 6000r comes with adapters installed on the bezel, which
ensure a proper fit between the bezel and the HP NetServer rack. These adapters
must be removed when installing the HP NetServer LT 6000r in a third-party
rack.

Remove the Bezel

Remove the bezel from the HP NetServer LT 6000r.
1. Carefully disconnect the control panel cable from the front of the server.
2. Unclip the control panel cable from the clip on the back of the bezel.
3. Lift the bezel off of the hinges to remove it.
Prepare the HP NetServer for Rack Mounting
7