Install Power Supply Fan Module - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3 HP NetServer LH 6000/6000r: Installing a Power Supply and Fan

Install Power Supply Fan Module

The redundant power supply fan module allows the NetServer to keep operating in
case the original fan fails.
1. Locate the power supply fan module, and press down on the tab to unlock
the hinged handle. As shown in Figure 3-1, this tab locks the handle in the
closed position.
Press down on the tab
to unlock the hinged handle.
Figure 3-1. Unlock the Hinged Handle on the Power Supply Fan Module
2. Locate the panel where you will insert the redundant power supply fan
module shipped with this upgrade kit. See Figure 3-2. As you insert the fan
module, this hinged panel rotates up and out of the way.
3. With the hinged handle open, insert the power supply fan module as shown
in Figure 3-2.
4. Press the power supply fan module into the connector and swing down the
hinged handle to lock the fan module into place.
12