HP D7171A - NetServer - LPr Installation Manual page 22

4. Hold the DIMM at a 90-degree angle to the system board.
5. Insert the DIMM carefully into the socket. The retaining clips
will close automatically if it is inserted properly.
CAUTION
6. Repeat Steps 1 through 5 to install all DIMMs.
7. On the NetServer LH 3r, reinstall the system board.
8. Replace the cover and bezel.
14
Do not rock the DIMM into place, but apply firm
and even pressure directly downward. If the
retaining clips do not close, remove the module and
repeat Steps 3 through 5.