Preparation; Removing The Cover (Netserver Lh 3) - HP D7171A - NetServer - LPr Installation Manual

Dimm installation guide

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Enlarged version

2 Preparation

This chapter includes guidelines and instructions for installing DIMMs

in the specified sequence on the system board.

To remove a cover:

1. Turn off the HP NetServer and disconnect the power cord and

telephone cord.

2. Unlock the bezel lock with the key from the key bag located on

the rear of the HP NetServer (see Figure 2-1).

3. To remove the front bezel, pull the top of the bezel away from the

chassis, and then lift the bezel up and off of the chassis.

4. Loosen the thumbscrew at the front of cover 3 and pull the cover

forward, using the handle on the cover, and then lift it off the

chassis (see Figure 2-1).

Table of Contents