Hard Disk Drive - IBM PC 300 Maintenance Service Manual

Hard Disk Drive

To remove or replace the hard disk drive:
Make sure to disconnect the power and signal cables from the CD-ROM drive and the diskette drive.
Pivot the latch that secures the lower drive-mounting tray. Slide the drive-mounting tray toward the rear of the computer
and remove it.
Note: If the chassis is not like the figure, please refer to the following.
Press down the latch.
Pivot the tray outward, then lift it slightly to remove it
Remove the four screws (two on each side) that hold the hard disk drive to the mounting tray.
Pull the hard disk drive from the mounting tray to remove it.
95