HP StorageWorks 2/128 - SAN Director Switch Release Note page 24

Issues and Workarounds
Table 6: Issues and Workarounds (Continued)
Web Tools shows incorrect current value on
the smart sfp.
Web Tools does not show duplicate entries
contained in zoning on switch, so you cannot
delete the duplicate entry.
The CP error SIOCADDRT: No such device
occurs on two separate SAN Director 2/128 CP
blades.
For debugging usage, PortID in the
portlogdump should refer to the area number
of the switchshow when Extended Edge PID is
set.
Incompatible flow control warning
messages should refer to the area number of
the switchshow when extended Edge PID
(format 2) is set.
Web Tool events use UTC time, rather than
adjusted timezone time.
24
Issue Workaround
Use the sfpshow command to display the
correct value of current.
Deleting one member out of the zone list from the
Telnet session may resolve the issue.
This problem can be mitigated by not setting the
switch IP address from multiple Telnet or
application sources (Telnet windows, Web Tools,
Fabric Manager, and so on). If you do see the
SIOCADDRT error message, you can resolve the
problem by properly setting the IP address with
the ipAddrSet command.
Note that after running portlogdump, the
PortID is the logical linear port number, not the
area number.
In switch PID format 2 (Extended Edge PID
format), this error message is shown as a logical
linear port, which is different from the area
number of switchshow. Add 16 to the logical
linear port number to match the switchshow
area number.
Note that Web Tools and CLI event time are not
the same when the tstimezone is configured.
When tstimezone is not configured, the event
times match.
SAN Director 2/128 Fabric OS 4.2.x Release Notes