Table 16 Port Class Default Settings - Brocade Communications Systems SN3000B Administrator's Manual

Port class default settings
Table 16
TABLE 16
Area
Cyclic redundancy
check (CRC)
Invalid transmission
words (ITW)
Class 3 discards
(C3TX_T0)
Link loss
Signal loss
Sync loss
Protocol errors (PE)
Received packets
(RXP)
Fabric Watch Administrator's Guide
53-1002153-02
provides default settings for areas in the Port class.
Port class default settings
Description
Monitors the
number of CRC
errors.
Monitors the
number of invalid
words transmitted.
Class 3 discards
frames due to time
out or destination
unreachable.
Monitors the
number of link
failures.
Monitors the
number of signal
loss errors.
Monitors the
number of loss of
synchronization
errors.
Monitors the
number of primitive
sequence errors.
Monitors receive
rate, by percentage.
Port class guidelines and default settings
Default threshold Default alarm settings
settings
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 1000
Buffer: 100
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 1000
Buffer: 100
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 5
Buffer: 0
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 500
Buffer: 50
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 5
Buffer: 0
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 500
Buffer: 50
Unit: Errors Below: 0
Time Base: minute Above: 0
Low: 0
High: 5
Buffer: 0
Unit: Percentage (%) Below: 0
Time Base: minute Above: 0
Low: 0
High: 100
Buffer: 0
7
Threshold state
Informative
Out_of_range
Informative
Out_of_range
Informative
Out_of_range
Informative
Out_of_range
Informative
Out_of_range
Informative
Out_of_range
Informative
Out_of_range
Informative
Informative
57