HP NetStorage 6000 User Manual page 177

Trap Event Log
Message Message
The power Power
supply X supply xx in
temperature the system
is too high. at location
yy is in
critical
condition:
the
temperature
is in a critical
range.
The power Power
supply X has supply xx in
no AC the system
power. at location
yy is in
critical
condition:
the AC
power is not
detected.
NetStorage Fan xx in the
6000 fan x system at
failed. location yy
failed.
The primary The primary
power cord power cord
failed. in the
system at
location yy
failed.
The The
secondary secondary
power cord power cord
failed. in the
system at
location yy
failed.
E-mail LCD
Message Message
Power P22 Power
supply xx in (X) overheat
the system
at location
yy is in
critical
condition:
the
temperature
is in a critical
range.
Power -
supply xx in
the system
at location
yy is in
critical
condition:
the AC
power is not
detected.
- -
The primary P31 Primary
power cord power cord
in the failed
system at
location yy
failed.
The P32
secondary Secondary
power cord power cord
in the failed
system at
location yy
failed.
Troubleshooting and Error Codes
Web Interface
Message
Power module x - Verify that the power
temperature supply switch and master
warning. power switch are both
turned on. Replace power
supply. The power supply
replacement kit provides
instructions.
Power module x - Check to insure that the
AC warning. power supply is properly
secured in the unit.
Replace the power supply
if this is not effective.
- Replace fan.
- Re-establish good
connection with power
cord or replace power
cord.
- Re-establish good
connection with power
cord or replace power
cord.
Hardware Error Codes
Solution
E-12