Copier Initial Setting [2] - Kyocera Mita Vi7360 Instruction Handbook Manual

Key Operator Mode

Copier Initial Setting [2]

Initial settings are the settings that display automatically when the copier is powered on,
when Auto/Reset timer is operated, or when [
settings can be changed by the key operator, as shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition to meet
Energy Star requirements:
Initial Setting
Copy Mode: 1-1
Copy Density: AES
Lens Mode: 1:1
Paper Tray: APS
Output Mode: offset sort
When Initial settings are changed by the key operator, the new initial settings display
when the copier is powered on, when Auto/Reset timer is reached, or when [
] key is pressed.
RESET
The following initial settings can be changed by the key operator:
Copy mode: [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density: [AES; manual]
Lens mode: [AMS; ratio 0.33~4.00]
Paper tray: [APS; trays 1, 2, 3, or 4]
Output mode: [non-sort; group; staple-sort; stapling & folding; folding; cover sheet]
Special original: [Image Quality; Text/Photo Enhance; Special Original; Original Form]
Rotation: OFF
Setting procedures are described on the following pages.
NOTE: The most commonly-used settings are established at installation. Before changing any of the copier
settings, be sure that you understand the overall and long-range effect of the change.
13-10 Key Operator Mode
] key is pressed. These
AUTO RESET
AUTO