Compact Flash Card Pwr Connector; Trusted Platform Module Header - Supermicro Supero H8SGL-F User Manual

H8SGL(-F) SERVERBOARD USER'S MANUAL

Compact Flash Card PWR Connector

A Compact Flash Card Power Connector
is located at JWF1. For the Compact Flash
Card to work properly, you will need to enable
with JCF1 and connect a Compact Flash
Card power cable to JWF1 fi rst.

Trusted Platform Module Header

The JLPC1 header is used to connect a
Trusted Platform Module (TPM), available
separately from a third-party vendor. A TPM
is a security device that allows encryption
and authentication of hard drives, disallowing
access if the TPM associated with it is not
installed in the system. See the table on the
right for pin defi nitions.
LAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside the
VGA port. Additionally, there is a dedicated
LAN for IPMI on top of the two rear USB
ports. These Ethernet ports accept RJ45
type cables.
Trusted Platform Module Header
Pin Defi nitions (JLPC1 )
Pin# Defi nition
1 LCLK
3 LFRAME
5 LRESET
7 LAD3
9 VCC3
11 LAD0
13 RSV0
15 SB3V
17 GND
19 LPCPD
LAN Ports (LAN1/2)
Pin# Defi nition
1 P2V5SB
2 TD0+
3 TD0-
4 TD1+
5 TD1-
6 TD2+
7 TD2-
8 TD3+
9 TD3-
Note: NC indicates no connection.
2-14
Pin# Defi nition
2 GND
4 No Pin
6 VCC5
8 LAD2
10 LAD1
12 GND
14 RSV1
16 SERIRQ
18 CLKRUN
20 RSV2
Pin Defi nition
Pin# Defi nition
10 SGND
11 Act LED
12 P3V3SB
13 Link 100 LED
(Yellow, +3V3SB)
14 Link 1000 LED
(Yellow, +3V3SB)
15 Ground
16 Ground
17 Ground
18 Ground