Compact Flash Card Pwr Connector; Sgpio Headers - Supermicro X7DBN User Manual

Compact Flash Card PWR
Connector
A Compact Flash Card Power
Connector is located at JWF1. For the
Compact Flash Card to work properly,
you will need to connect the Compact
Flash Card power cable to JWF1 fi rst
and then enable the Compact Flash
Connector by closing JCF1. Refer to the
board layout below for the location.

SGPIO Headers

There are two SGPIO (Serial General
Purpose Input/Output) headers (J29,
J30) located on the motherboard. These
headers support serial link interfaces for
the onboard SATA and SAS connectors.
See the table on the right for pin
defi nitions. Refer to the board layout
below for the location.
GLAN1
GLAN2
S IMLP IPMI
S E PC
P C I-E xp x8
P C I-E xp x4
Compact Flash Card PWR
Jumper Defi nition
On
Off
Pin# Defi nition
1 *NC
3 Ground
5 Load
7 *NC
*Note: NC= No Connections
S MB PS
PSF
J 3P
(CPUFan1)
J A R
C
B
A
2-23
Chapter 2: Installation
Connector
Compact Flash
Power On
Compact Flash
Power Off
SGPIO
Pin Defi nitions
Pin Defi nition
2 *NC
4 Data
6 Ground
8 *NC
A. Compact Flash PWR
8-pin P W R
B. SGPIO1
B. SGPIO2
(CPUFan2)