Compact Flash Card Pwr Connector; Unit Identifi Cation Switches - Supermicro X7DBR-8 Plus User Manual

Compact Flash Card PWR
Connector
A Compact Flash Card Power Connector is
located at JWFR. For the Compact Flash
Card or the Compact Flash Jumper (JCF1)
to work properly, you will need to connect
a power cable to JWFR fi rst. Refer to the
board layout below for the location.
Unit Identifi cation Switches
There are two Unit Identification (UID)
Switches on the motherboard. The Front
Panel UID Switch (JUID1) is connected to
the Front Control Panel. The Back Panel
(BP) UID Switch (JUID2) is located next to
DIMM#4D. When you push the UID Switch
(JUID1) on the Front Control Panel, both
BP UID and FP UID Indicators will be lit.
Push the UID Switch again to turn off both
Indicators. These UID Indicators provide
easy identifi cation of a system unit that may
be in need of service.
C
GLAN1
PCI-X 133MHz
GLAN2
SCSI
CTRLR
4-pin
8-pin
PWR
SMBus PWR
PWR
JPWF
B
A
SXB- SXB-
2-23
Chapter 2: Installation
Compact Flash Card PWR
Connector
Jumper Defi nition
On Power On
Off Power Off
A. Compact Flash PWR
Connector
FP Control
B. Front Panel UID
Switch (JUID1)
JUID1
JOH1
JP1 C. Back Panel UID
Switch (JUID2)