Flexible Arm Installation; Remove Monitor Stand For Mounting - NEC MultiSync PA231W User Manual

Flexible Arm Installation

This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
NOTE: For PA301W, the monitor must be installed or moved by two or more people.
• Follow the instructions provided by the manufacturer of the display mount.
• To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See pages 26-29 for details on each model. Remove the monitor stand before mounting.

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Figure S.1).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the arrows
(Figure S.1).
5. Lift up the stand to unhook it from the monitor (Figure S.1).
The monitor can now be mounted using an alternate method.
Reverse process to reattach stand.
NOTE: Handle with care when removing monitor stand.
Mount Flexible arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how Remove Monitor Stand for
Mounting to remove the stand.
2. Using the 4 screws from the stand removal and attach the arm to
the monitor (Figure F.1).
Caution: Use ONLY the screws (4 pcs) that are included or the
screws M4 size (Length: thickness of bracket and washer +
10-12 mm) when mounting to avoid damage to the monitor
and stand. To fulfi l the safety requirements the monitor
must be mounted to an arm which guaranties the
necessary stability under consideration of the weight of
the monitor. The LCD monitor should only be used with
an approved arm (e.g. GS mark).
Unit
10-12 mm
NOTE: Tighten all screws.
(recommended Fasten Force: 98 - 137N•cm)
*2 Only for PA271W/PA301W.
Mounting
Bracket
Washer
Screw
Thickness
of bracket
and washer
200 mm* 2 100 mm
Weight of LCD assembly: 7.0 kg (PA231W)
English-8
Figure S.1
100 mm
7.4 kg (PA241W)
9.6 kg (PA271W)
12.5 kg (PA301W)
Figure F.1