To Prevent Damage; Notice For The Blue/White Lead - Pioneer SPH-DA02 Operation Manual

Connecting the system

To prevent damage

WARNING
! Use speakers over 50 W (output value)
and between 4 W to 8 W (impedance value).
Do not use 1 W to 3 W speakers for this
unit.
! The black cable is ground. When instal-
ling this unit or power amp (sold sepa-
rately), make sure to connect the ground
wire first. Ensure that the ground wire is
properly connected to metal parts of the
car's body. The ground wire of the power
amp and the one of this unit or any other
device must be connected to the car sepa-
rately with different screws. If the screw
for the ground wire loosens or falls out, it
could result in fire generation of smoke or
malfunction.
Ground wire
Other devices
Metal parts of car's body
(Another electronic
device in the car)
*1
Not supplied for this unit.
! When replacing the fuse, be sure to only
use a fuse of the rating prescribed on this
product.
! When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
! This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
ACC position
! To avoid short-circuiting, cover the discon-
! Refer to the owner's manual for details on
! Since a unique BPTL circuit is employed,
! If the RCA pin jack on this product will not
Power amp

Notice for the blue/white lead

! When the ignition switch is turned on (ACC
! Be sure not to use this lead as the power
! Be sure not to use this lead as the power
No ACC position
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
connecting the power amp and other units,
then make connections accordingly.
do not directly ground the * side of the
speaker lead or connect the * side of an-
other side of the speaker lead together. Be
sure to connect the * side of the speaker
lead to the * side of the speaker lead on
this product.
be used, do not remove the caps attached
to the end of the connector.
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control term-
inal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the AV source is switched off.
supply lead for the external power amps.
Such connection could cause excessive
current drain and malfunction.
supply lead for the auto-antenna or anten-
na booster. Such connection could cause
excessive current drain and malfunction.
Section
02
5
En