Getting Started
SOURCE/
Rotary encoder
/ENTER
AUDIO/SETUP
e
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set
Turning Power On and Off
Press SOURCE to turn on the unit.
Note
• The unit can be turned on by pressing any other button except and
e.
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press SOURCE to change the source.
HD RADIO DISC USB AUDIO/iPod
HD RADIO
*1 Only when the iPod/iPhone is connected.
*2 Only when AUX SETUP is set to ON. For details, refer to
"Setting the AUX SETUP Mode" on page 20.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press e at the lower left side until the front panel pops
out.
8
-EN
3
Notes
• The front panel may become hot in normal usage (especially the
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
1
2
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
• Attach the front panel carefully, holding the sides of the front panel to
Initial System Start-Up
Be sure to press the RESET button when using the unit for the first time,
after changing the car battery, etc.
1
2
*1
*2
AUXILIARY
3
Grasp the left side of the front panel and pull it out.
connector terminals on the back of the front panel). This is not a
malfunction.
result in malfunction.
Attaching
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
Push the left side of the front panel until it locks firmly into
the main unit.
on the connector terminals and no foreign object between the front
panel and the main unit.
avoid pushing buttons by mistake.
Turn off the unit power.
Remove the detachable front panel.
Press RESET with a ballpoint pen or similar pointed object.
RESET button