Terminology; Adjusting Subwoofer Level/Bass Level/Middle Level/Treble Level/Balance (Between Left And Right)/Fader (Between Front And Rear)/Loudness/Defeat; Sound Setting - Alpine CDE-134HD Quick Reference Manual

Formats supported
This device supports CD-ROM XA, Mixed Mode CD, Enhanced CD
(CD-Extra) and Multi-Session.
This device cannot correctly play back discs recorded with Track At
Once or packet writing.
Order of files
Files are played back in the order that the writing software writes them
to the disc. Therefore, the playback order may not be what is expected.
Verify the writing order in the software's documentation. The playback
order of the folders and files is as follows.
Root folder
Folder
* The folder No./ folder Name will not be displayed if no file is contained
in the folder.

Terminology

Bit rate
This is the "sound" compression rate specified for encoding. The higher
the bit rate, the higher the sound quality, but also the larger the files.
Sampling rate
This value shows how many times per second the data is sampled
(recorded). For example, music CDs use a sampling rate of 44.1 kHz, so
the sound is sampled (recorded) 44,100 times per second. The higher
the sampling rate, the higher the sound quality, but also the larger the
volume of data.
Encoding
Converting music CDs, WAVE (AIFF) files, and other sound files into the
specified audio compression format.
Tag
Song information such as track titles, artist names, album names, etc.,
written into MP3 files.
Root folder
The root folder (or root directory) is found at the top of the file system.
The root folder contains all folders and files. It is created automatically
for all burned discs.
14
-EN
MP3 File

Sound Setting

Rotary encoder

/ENTER
AUDIO/SETUP
Adjusting Subwoofer Level/Bass Level/
Middle Level/Treble Level/Balance (Between
Left and Right)/Fader (Between Front and
Rear)/Loudness/Defeat
1
Press AUDIOSETUP repeatedly to choose the desired
mode.
Each press changes the mode as follows:
*1 *2
 BASS LEVEL
SUBWOOFER
BALANCE  FADER  LOUDNESS
SUBWOOFER
*1 When the subwoofer mode is set to OFF, its level cannot be
adjusted.
*2 Adjustable only when DEFEAT is OFF.
*3 For details about loudness, refer to "Turning Loudness On/Off "
on page 15.
Subwoofer
Bass level
Middle level
Treble level
Balance
Fader
Loudness
Defeat
Volume
Note
• If no operation is performed for 5 seconds, the unit automatically
returns to normal mode.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of BASS,
MID, TRE LEVEL and LOUDNESS will return to the factory
defaults.
*2 *2
 MID LEVEL  TRE LEVEL 
*2/*3
 DEFEAT  VOLUME 
+0 ~ +15
-7 ~ +7
-7 ~ +7
-7 ~ +7
L15 ~ R15
R15 ~ F15
ON/OFF
ON/OFF
0 ~ 35