Using Remote Control; Installing And Removing Batteries; Setting Remote Control Id Numbers - Panasonic PT-VX400NTU Operating Instructions Manual

Using Remote control

Using Remote control

Installing and Removing batteries

1 ) Open the cover

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
Setting the ID number
J
1) While holding down the <MENU> button, press the Number Buttons, the number
you press the Number buttons corresponds to the desired ID code number.
2) The number you press the number buttons are as follows: Code 1= <1 MUTE>,
Code 2= <2 D.ZOOM +>, Code 3= <3 VIDEO>,
Code 4= <4 FREEZE>, Code 5= <5 D.ZOOM ->, Code 6= <6 S-VIDEO>.
3) The ID code is reset to [ALL] (default) by pressing the <MENU> button and
<0 LAMP> button at the same time for 5 seconds or more.
Attention
The status of the ID code is not stored after replacing batteries.
z
Note
For details, please refer to the [Remote control] of the [Setting] menu.
z
( page 61)
Æ
24
- ENGLISH
2 ) Install batteries and close the cover
(Insert the – side first.)
Remove the batteries in the reverse order of
z
installation.
MENU button
Number buttons