P-Timer; Closed Caption - Panasonic PT-VX400NTU Operating Instructions Manual

Setting
Attention
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
If [Standby mode] is set to [Eco], the signals come
z
from MONITOR OUT and AUDIO OUT terminal are
unavailable.
If [Standby mode] is set to [Eco], you can not use
z
network functions when the projector is standing by. Also,
you cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions
z
when the projector is standing by. Refer to "Operating
Instructions - Network Operations

P-timer

This function allows you to change the setting of the
P-timer and execute it.
1 ) Press ▲▼ to select [P-timer].
2 ) Press ► or <SELECT> button to
access the submenu.
Mode
J
1 ) Press ▲▼ button to select one mode
among the items as below.
Count up
Count down
Timer
J
1 ) Press ▲▼ to select [Timer] and then
press the <SELECT> button.
2 ) Press▲▼ to set the [Timer](1-180 Min).
Timer is available in [Count down] only. Factory
z
default value is 10 Min.
Execute
J
1 ) Press ▲▼ to select one among the
items as below and then press the
<SELECT> button.
Start It executes the count up or count
down function.*
Reset Reset the P-timer values.*
Exit To exit the P-timer operation.
60
- ENGLISH
".
The P-timer display 000:00
appears on the screen and the
count up starts (000:00-180:00)
The time set in the Timer setting
appears on the screen and the
countdown starts.
1
2
*1 : Press the <SELECT> button at [Start] and the
indication changes into [Stop]. To stop [Count up]
or [Count down], press the <SELECT> button at
[Stop] on the screen menu, then the indication
changes into [Restart]. Press the <SELECT>
button at [Restart] to resume [Count up] or [Count
down].
*2 : Press the <SELECT> button at [Reset] to return
to the following value:
Count up "000:00"
Count down Timer that you set
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.

Closed caption

[Only for NTSC, 480i input]
1 ) Press ▲▼ to select [Closed caption].
2 ) Press ► or the <SELECT> button to
enter the submenu.
Closed caption
J
1 ) Press ▲▼ to select [Closed caption]
and then press the <SELECT> button.
2 ) Press ▲▼ to select Off, CC1, CC2,
CC3 or CC4.
Color
J
1 ) Press ▲▼ to select [Color] and then
press the <SELECT> button.
2 ) Press▲▼ to select color or white.
Attention
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when [NTSC] or [480i]
z
signals are input.
Part of characters may not displayed when high
z
compensation valued are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.