Pointer; Terminal; Power Management; Direct On - Panasonic PT-VX400NTU Operating Instructions Manual

Pointer

You can emphasize a part of the projected image with
this function.
1 ) Press ▲▼ to select [Pointer].
2 ) Press ► or the <SELECT> button to
access the submenu.
3 ) Press ▲▼ to choose one item among
the items such as the size of Spotlight
(Large/Middle/Small) and the pattern of
Pointer (Arrow/Fingertip/Dot).
Note
When you reset the [Pointer] function, the remote control
z
code will be reset, as well.

Terminal

The COMPUTER IN 2/ MONITOR OUT terminal on
the back of the projector is switchable for computer 2
input or monitor output.
1 ) Press ▲▼ to select [Terminal] and
then press the <SELECT> button .
2 ) Press ▲▼ to switch the item.
Computer 2 Computer input
Monitor out Monitor out
Note
Terminal function is not available when selecting
z
[Computer 2] to the input source. Change the input
source to the others (HDMI or Computer 1 or Video) so
that the [Terminal] function will be available.

Power management

For reducing power consumption as well as
maintaining the lamp life, the [Power management]
function turns off the projection lamp when the
projector is not operated for a certain period.
1 ) Press ▲▼ to select [Power
management].
2 ) Press ► or the <SELECT> button to
access the submenu.
Mode
J
1 ) Press ▲▼ and then press the
<SELECT> button to select one mode
among the items as below.
Ready When the lamp has been fully cooled
down, the <POWER> indicator
changes to green blinking. In this
condition, the projection lamp will
be turned on if the input signal is
reconnected or any button on the
control panel or remote control is
pressed.
Shut When the lamp has been fully cooled
down
down, the power will be turned off.
Off
Power management function is off.
Timer
J
1 ) Press ▲▼ to select [Timer] and then
press the <SELECT> button.
2 ) Press ▲▼ to set the Timer(1~30min).

Direct on

1 ) Press ▲▼ to select [Direct on] and
then press the <SELECT> button.
2 ) Press ▲▼ to switch between On and
Off.
When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the [Direct On] function does not work properly.

Standby mode

This function can set the electric power when the
projector is standing by.
1 ) Press ▲▼ to select [Standby mode]
and then press the <SELECT> button.
2 ) Press ▲▼ to switch between the items
as below.
Restricts some functions in
Eco standby mode to reduce power
consumption.
Does not restrict functionality
Network
even in standby mode.
Setting
59
ENGLISH -