Attaching the Ceiling Mount to the Ceiling
When installed with the
AN-TK201
1
1
Attach the ceiling mount to the
ceiling.
•
First, lightly screw an installation bolt into
the smallest hole
doing the same for the holes
Once the position has been decided, fi rmly
tighten all four bolts.
•
Use M8-type bolts. (Bolt type may vary
depending on the method of installation.)
the washers supplied with the
•
Use
ceiling mount.
2
2
Attach the height-adjustment
pole to the ceiling mount.
1.
Insert the height-adjustment pole
the ceiling mount.
2.
Fix the pole in place with the sleeve and
pole-fi xing bolt
of the screen.
3.
Lock the bolt in place with the securing
nut
.
4.
Screw in the two stabilizing screws
5.
Tighten the securing nut
the pin
into the hole on the pole-fi xing
bolt.
Caution
•
Ask your dealer or service shop to install the
ceiling mount. Sharp will assume no
responsibility whatsoever if inadequate
installation causes your projector or attached
devices to fall out of place.
and then proceed,
,
and
.
into
, according to the height
.
fi rmly and fi t
Washer
Washer
Mounting bolt (M8-type)
Mounting bolt (M8-type)
Pin hole
Pin hole
Sleeve
Sleeve
79