Setting The Video System; Setting The Video Setup; Selecting The Dynamic Range; Checking The Input Signal - Sharp XG-SV200X Operation Manual

5 Setting the Video System

The video input system mode is factory preset
to "Auto"; however, a clear picture from the
connected audio-visual equipment may not be
received, depending on the Video signal
difference. In that case, switch the Video
signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL-60
* When reproducing NTSC signals in PAL video
equipment.
Note
• The Video signal can only be set in VIDEO or
S-VIDEO mode.
• When "Video System" is set to "Auto", you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.

6 Setting the Video Setup

Selectable
items
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
Note
• This function is available for the following
signals.
With COMPUTER/COMPONENT 1 or 2 input:
- 480 I
With S-VIDEO or VIDEO input:
- NTSC3.58
Description
Menu operation n Page

7 Selecting the Dynamic Range

An optimum picture may not be displayed if an
HDMI capable device's output signal type and
the projector's input signal type do not match.
If this should occur, switch "Dynamic Range".
Selectable
items
Auto When the black levels of the image
show banding or appear faded, select
Standard
the item that results in the best picture
quality. (In most circumstances,
Enhanced
"Standard" should be selected.)
Note
• The Dynamic Range can be selected only
when "HDMI" input mode is selected.

8 Checking the Input Signal

This function allows you to check the current
input signal information.
46
Description
53