The Connection/Power Menu - Sony VPL-SX535 Operating Instructions Manual

The Connection/Power Menu

The Connection/Power menu is used for setting for the connections and power.
Items
Network Setting
IP Address Setup Auto (DHCP): The IP address is assigned automatically from the
Input-A Signal Sel.
Color System
Eco
Lamp Mode
AUTO POWER SAVIING
With No Input
With Static
Signal
Standby Mode*
Direct Power On
22
The Connection/Power Menu
Item descriptions
DHCP server such as a router.
Manual: To specify the IP Address manually.
Auto/Computer/Video GBR/Component: When set to "Auto," selects
the type of video signal input automatically when "Input-A" is selected
with the INPUT key.
Auto/NTSC /PAL/SECAM/NTSC
3.58
"Auto," selects the color system automatically when "S Video" or
"Video" is selected with the INPUT key.
High/Standard/Low: When set to "High," the image becomes brighter,
and power consumption becomes higher.
Lamp Cutoff: The lamp turns off automatically and power
consumption is reduced if no signal is input for more than 10 minutes.
The lamp lights again when a signal is input or any key is pressed. In
Lamp Cutoff, the ON/STANDBY indicator lights in orange. (page 30)
6
Standby* : If no signal is input to the unit for more than 10 minutes,
the power turns off automatically, and the unit enters standby mode.
Off: You can deactivate the With No Input.
Lamp Dimming: If an image does not change for about 10 seconds,
lamp output is gradually reduced (approximately 10% to 15%*
that set in the Lamp Mode.*
approximately 30% of its lamp output according to the selected time
(with no change to input signal) "5," "10," "15," "20" minutes or
"Demo.," While dimming the lamp, the message "Lamp Dimming"
appears. If you select "Demo.," the image will start to darken about
35 seconds later. When any change in signal is detected, or an operation
(remote control or control panel) is performed, normal brightness is
5
restored.*
Off: You can deactivate the With Static Signal.
2
Standard/Low: When set to "Low," lowers power consumption in
Standby mode.
On/Off: When set to "On," you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet.
With the projector turned off, you can also unplug the AC power cord
without going to Standby mode, regardless of the Direct Power On
setting.
*1
/PAL-M/PAL-N: When set to
4.43
*1
4
Automatically the lamp slowly darkens to
3
) from