Step 6-Configuring Raid Devices - HP Xw4600 - Workstation - 2 GB RAM Installation Manual

Lsi megaraid sas 8888elp host bus adapter

Hide thumbs Also See for Xw4600 - Workstation - 2 GB RAM:

Table of Contents

Figure 10

Attaching the HDD-LED cable

Step 4—Reassembling the workstation

Reinstall the card support, if applicable.

Reinstall the side access panel.

Reconnect power to the workstation and all external devices.

Restore power to the workstation and all external devices.

Step 5—Loading and setting up driver software

For instructions on loading and setting up the SAS drivers for use with your workstation, see the

manufacturer's documentation shipped with the 8-port SAS RAID controller.

At the time of component installation, look for device firmware and driver updates, designated for your

workstation model and operating system. You can obtain updates from

workstationsupport.

Step 6—Configuring RAID devices

NOTE:

Verify the RAID card internal data connectors are enabled. For card setup instructions, see

the manufacturer's documentation included in this kit.

For detailed instruction on configuring RAID devices, see the service guide for the HP workstation model

at http://www.hp.com/support/workstation_manuals.

Additional information is available at

LSI MegaRAID® SAS 8888ELP Host Bus Adapter installation

http://www.hp.com/support/RAID_FAQs

http://www.hp.com/go/

ENWW

Table of Contents