Installing The Drive - HP Xw4550 - Workstation - 2 GB RAM Installation Manual

WARNING!
cord is unplugged from the electrical outlet.
4. Remove the access panel from the workstation, then remove the front bezel by using the green
tabs.
WARNING!
personal injury from hot surfaces.

Installing the drive

Complete the following steps to install the drive:
NOTE: Your workstation may not be identical to the workstation shown in the following illustrations. If
you need more information, refer to the documentation included with the workstation for drive installation
procedures.
NOTE: There may be drive length limitations for some of the drive bays in certain workstations.
1. Select a drive bay position on the workstation to install the new drive, as shown below.
NOTE:
drive.
Item
1
2
3
6 SATA optical drive installation
To avoid the risk of serious injury or damage to the workstation, ensure that the power
Allow the internal system to cool before touching in order to reduce the risk of
It is recommended that the next highest available bay be used when installing the new
Function
CD/DVD drive
Optical drive bay
Optical drive bay
ENWW