HP XM600 - Kayak - 128 MB RAM Troubleshooting Manual page 7

Your PC Workstation Does Not Start Correctly
Symptom
When the power button is pressed, the PC
Workstation shows no sign of activity at all:
• Monitor is blank.
• No hard disk drive or fan noise.
• MaxiLife status panel does not light up.
When the power button is pressed, the PC
Workstation appears to boot, but monitor remains
blank:
• Hard disk drive and fan can be heard.
• Status LED is GREEN.
• MaxiLife status panel displays a smiling face .
When the power button is pressed, the PC
Workstation does not boot:
• Hard disk drive and fan can be heard.
• Monitor remains blank.
• Status LED is RED (solid or flashing).
• MaxiLife status panel displays an error message
with a sad face .
When the power button is pressed, the PC
Workstation starts to boot and there is activity on
the monitor:
• Boot process fails with an error message.
• Status LED flashes RED.
• Beep code emitted.
• MaxiLife status panel displays a sad face
a POST error message.
When the power button is pressed, the PC
Workstation starts to boot and there is initially
some activity on the monitor, but then:
• Screen becomes blank.
or
• Image is corrupt.
Type of Problem
•
PC Workstation may not be correctly connected to
the power supply.
•
Monitor may be badly connected or not switched
on.
•
HP MaxiLife has detected a hardware
configuration error. A component may be badly
connected inside the PC Workstation.
•
Configuration error has been detected by the
POST (Power-On Self Test).
and
• Video card may be improperly installed or
incorrectly configured.
• Hard disk drive failure or not accessible.
Refer to page 9.
Refer to page 11.
Refer to page 13.
Refer to page 16.
Refer to page 19.