HP XM600 - Kayak - 128 MB RAM Troubleshooting Manual page 14

Symptom...
Power-On-Self-Test (POST) displays a memory test error and a Beep code is emitted (1-3-3-1).
ERROR !
Memory Error
ERROR !
No RIMM
Refer to the memory installation table on the following page.
Power-On-Self-Test (POST) displays a video test error and a Beep code is emitted (1-2).
Symptom...
ERROR !
No Video
Possible Cause...
•
Cables are incorrectly fitted to
the corresponding system
board connectors.
•
System board switches
incorrectly set.
Your PC Workstation Does Not Start Correctly
Case 3 — Detected Hardware Configuration Error
Check that...
•
Memory incorrectly installed.
•
Memory modules are secured in
place with the two retaining clips.
•
RDRAM module is not installed in
the specified socket (furthest from
the processor) for the SDRAM
Memory Expansion Card.
•
RDRAM modules are incorrectly
installed in the RIMM sockets.
•
Missing RDRAM modules.
Check that...
Video card is:
•
Present.
•
Seated correctly in the AGP connector.
•
Cabled correctly.
•
Not defective.
Check that...
Cables are correctly connected.
If required, refer to the service label inside the cover for the system board layout.
Refer to the service label inside the cover for correct settings.
Or, refer to "System Board Switches" on page 36.
14
Symptom...
ERROR !
Contin Module
ERROR !
No DIMM
Case 3 — Detected Hardware Configuration Error is continued on the next page
Check that...
•
Continuity modules incorrectly
installed or not installed at all.
•
SDRAM modules are incorrectly
installed in the DIMM sockets.
•
Missing SDRAM modules.