HP VL600 - Vectra - 128 MB RAM Installation Manual page 24

Connecting to a Windows NT 4.0 Server
Microsoft Windows 98 2nd edition
10 Accept the default selection: "Search for the best driver for your device
(Recommended)." and click "Next".
11 Select the locations Windows 98 will search for drivers. Accept the default
selection: "Floppy disk drives" and click "Next".
12 Select "The updated driver (Recommended) 3Com EtherLink 10 ISA TPO
(3C509b-TPO) in PnP mode" and click "Next".
13 Click on "Next" to continue with the installation.
14 Click on "OK" when Windows prompts for the driver disk.
15 Type in the location of the floppy drive containing the driver disk and click
on "OK".
16 At the "3COM Installation Wizard" window, select "Express Installation",
"Custom Installation", or "Skip the 3COM Installation Wizard" and click on
"Next" (Express Installation is typical). If you do not have a DHCP server
on your network, or if you have a static IP address, you must use Custom
installation. For Custom installation, ask your Network Administrator for
more information.
17 If either Express or Custom Installation was selected, click on "Finish" to
complete the 3COM Installation Wizard. Otherwise, proceed to the next
step.
18 Click on "Finish" when the driver installation is complete.
19 Remove the driver disk and click on "Yes" to restart the system.
20 After restarting the system, additional changes in the network properties,
such as: workgroup name, computer name, etc. may be necessary. Ask
your Network Administrator for more information. Restart the system if
changes are made.
Known Problems
Problem1
After running PREINST.EXE, a message indicating "A Plug and Play BIOS
was not detected in your computer!" comes up.
This message can be safely ignored. There is no known fix to this problem.
22