HP Tc2100 - Server - 128 MB RAM Installation Manual page 80

Chapter 9
9. Verify the DIMMs are installed correctly and fully seated.
10. Verify the DIMM notches are aligned to the keys in the DIMM connector.
After Installing an Accessory:
1. Turn off the monitor, the Server, and any external devices.
2. Unplug all cables from the power outlet.
3. Remove the cover.
4. Check the following:
o If you have installed an accessory board, verify the board is firmly seated
in its slot and any switches or jumpers on the accessory board are properly
set.
Refer to the documentation provided with accessory board.
o Check all internal cabling and connections.
o If you have changed any switches on the system board, verify each one is
properly set.
NOTE Only two of the eight switches on configuration switch are
used.
5. Replace the cover and connect all cables.
6. Turn on the monitor and Server.
7. If the Server still does not work:
o Repeat steps 1, 2, and 3 of this section.
o Remove all accessories, except the primary boot hard disk drive.
o Replace the cover and connect all cables.
o Turn on the monitor and the Server.
o If the Server now works, replace the boards and accessories one at a time
to determine which one is causing the problem.
8. If the Server still does not work contact your service representative to replace
the Server.
74
Troubleshooting