System Board - HP t100 Maintenance And Service Manual

5. Rotate the power supply to its full upright position (1), pull the power supply forward (2) until the
posts on the power supply move forward in the power supply bracket (3), and then lift the power
supply straight up and out of the chassis.
Figure 6-53
To install the power supply, reverse the removal procedure.
CAUTION:
are not cut by the drive cage and are not pinched by the rotating power supply.

System Board

1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove all PCI and PCI Express expansion boards
4.
Remove the baffle from the chassis
5.
Remove the fan from the chassis
6.
Rotate the drive cage to its upright position.
7.
Rotate the power supply to its full upright position.
8.
Disconnect all data and power cables from the system board.
9. If applicable, disconnect the serial port from the system board.
10. Disconnect the balance of the cables from the system board.
11. Remove the heat sink
Removing the power supply
When installing the power supply cables, make sure they are properly positioned so they
(Access Panel on page
(Heat sink on page
(Preparation for Disassembly on page
43).
(Expansion Cards on page
(Baffle on page 79).
(Front Fan Assembly on page
84).
42).
50).
80).
System Board
87