HP t100 Maintenance And Service Manual page 177

Desktop and thin clients
Hide thumbs Also See for t100:
Table of Contents

Advertisement

Table K-1
Solving General Problems (continued)
Poor performance is experienced.
Cause
Hard drive is full.
Low on memory.
Hard drive fragmented.
Program previously accessed did not release reserved memory
back to the system.
Virus resident on the hard drive.
Too many applications running.
Some software applications, especially games, are stressful on
the graphics subsystem
Cause unknown.
Computer powered off automatically and the Power LED flashes Red two times, once every second,
followed by a two second pause, and the computer beeps two times. (Beeps stop after fifth iteration but
LEDs continue flashing).
Cause
Processor thermal protection activated:
A fan may be blocked or not turning.
OR
The heatsink is not properly attached to the processor.
Solution
Transfer data from the hard drive to create more space on the
hard drive.
Add more memory.
Defragment hard drive.
Restart the computer.
Run virus protection program.
1.
Close unnecessary applications to free up memory.
2.
Add more memory. Some applications run in the
background and can be closed by right-clicking on their
corresponding icons in the task tray. To prevent these
applications from launching at startup, go to Start >
Run and type msconfig. On the Startup tab of the
System Configuration Utility, clear applications that you
do not want to launch automatically.
1.
Lower the display resolution for the current application or
consult the documentation that came with the application
for suggestions on how to improve performance by
adjusting parameters in the application.
2.
Add more memory.
3.
Upgrade the graphics solution.
Restart the computer.
Solution
1.
Ensure that the computer air vents are not blocked and
the processor cooling fan is running.
2.
Open hood, press power button, and see if the processor
fan spins. If the processor fan is not spinning, make sure
the fan's cable is plugged onto the system board header.
3.
If fan is plugged in, but is not spinning, then replace the
heatsink/fan assembly.
4.
Contact an authorized reseller or service provider.
Solving General Problems
167

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T150Ms6000

Table of Contents