HP t100 Maintenance And Service Manual page 38

Table 3-6
Option
Execute Memory
Test (some models)
BIOS Power-On
Onboard Devices
PCI Devices
PCI VGA
Configuration
Bus Options
Device Options
28 Chapter 3 Computer Setup (F10) Utility
Computer Setup—Advanced (for advanced users) (continued)
Description
Restarts the computer and executes the POST memory test.
Allows you to set the computer to turn on automatically at a time you specify.
Allows you to set resources for or disable onboard system devices (serial port or parallel port).
●
Lists currently installed PCI devices and their IRQ settings.
● Allows you to reconfigure IRQ settings for these devices or to disable them entirely. These
settings have no effect under an ACPI-based operating system.
Displayed only if there are multiple PCI video adapters in the system. Allows you to specify which
VGA controller will be the "boot" or primary VGA controller.
NOTE: In order to see this entry, you must enable Integrated Video (Advanced > Device
Options) and Save Changes and Exit.
On some models, allows you to enable or disable:
●
PCI SERR# Generation.
● PCI VGA palette snooping, which sets the VGA palette snooping bit in PCI configuration
space; only needed when more than one graphics controller is installed.
Allows you to set:
●
Printer mode (Bi-Directional, EPP + ECP, Output Only).
● Num Lock state at power-on (off/on).
●
S5 Wake on LAN (enable/disable).
◦
To disable Wake on LAN during the off state (S5), use the arrow (left and right) keys to
select the Advanced > Device Options menu and set the S5 Wake on LAN feature
to Disable. This obtains the lowest power consumption available on the computer during
S5. It does not affect the ability of the computer to Wake on LAN from suspend or
hibernation, but will prevent it from waking from S5 via the network. It does not affect
operation of the network connection while the computer is on.
◦
If a network connection is not required, completely disable the network controller (NIC)
by using the arrow (left and right) keys to select the Security > Device Security menu.
Set the Network Controller option to Device Hidden. This prevents the network