First Time Installation - HP BladeSystem bc2000 - Blade PC Installation Manual

Bladesystem pc blade switch

Hide thumbs Also See for BladeSystem bc2000 - Blade PC:

Table of Contents

First Time Installation

After completing all external connections, connect a terminal (with terminal emulation software) to the

Integrated Administrator 's external DB-9 RS232 serial port. To configure the Integrated Administrator,

please refer to the Integrated Administrator documentation. Ensure that the terminal emulation software

is configured as follows:

Integrated Administrator external serial port: 9600 baud.

Set the data format to 8 data bits, 1 stop bit, and no parity.

Set Flow Control to none.

Under Properties, select VT100 for Emulation mode.

Select Terminal keys for Function, Arrow, and

(not Windows keys).

NOTE:

When using HyperTerminal with Microsoft Windows 2000, make sure that Windows 2000

Service Pack 2 or later is installed. With Windows 2000 Service Pack 2, the arrow keys function properly

in HyperTerminal VT100 emulation. For more information about Windows 2000 service packs, go to

http://www.microsoft.com.

Chapter 2 First Time Installation

Ctrl

keys. Ensure that the setting is for Terminal keys

ENWW

Table of Contents