Set Interface Active - HP BladeSystem bc2000 - Blade PC Reference Manual

Ethernet Configuration Commands

set interface active

The set interface active Privileged EXEC mode command reactivates an interface that was
shutdown.
Syntax
set interface active {ethernet interface | port-channel port-channel-number}
Parameters
interface — Valid Ethernet port. (Full syntax: port)
n
port-channel-number — Valid port-channel number.
n
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode
Command Usage
This command is used to activate interfaces that were configured to be active, but were shut
down by the system for some reason (for example, port security).
Example
The following command reactivates interface e45.
Console# set interface active ethernet e45
8-12 www.hp.com HP PC Blade Switch CLI Reference Guide