• Always use an assistant or mechanical lifting equipment to safely lift and position the projector mount.
Slide connection block with projector into projector mount
assembly (A) as shown. Tighten captive screw to secure
projector to projector mount assembly (A).
FRONT OF MOUNT
To adjust yaw (swivel) for threaded rod mounting applications: Loosen locknuts on threaded rods
(step 5), until projector mount can be rotated. Rotate mount to desired position and retighten locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand
for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
FRONT OF MOUNT
ACCESS SLOT FOR
OPEN END WRENCH
SCREW FOR YAW (SWIVEL) STOP
(REFER TO STEP 2, INSTALLATION
TO EXTENSION COLUMNS, FIG. 2.3)
Visit the Peerless Web Site at www.peerlessmounts.com
Accessories listed in the included sheet, as well as other parts,
can be ordered through Peerless by calling 1-800-729-0307 or
9 of 9
All other brand and product names are trademarks or registered trademarks of their respective owners.
IMPORTANT: For security installations, insert
one #10-32 x 1/4" socket pin screw (D) through
projector mount assembly (A) and into connection
block as shown.
KNOB FOR PITCH
BACK OF MOUNT
KNOB FOR ROLL
ISSUED: 06-16-09 SHEET #: 055-XXXX-1
For customer care call 1-800-729-0307 or 708-865-8870.
© 2006 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries.