Duplex Motor Removal - Lexmark 522n - C Color Laser Printer Service Manual

4520-xxx

Duplex Motor Removal

1. Remove the duplex front cover door.
2. Gently disconnect the cables from the duplex board.
Warning: To avoid damage to the cables and connectors.
3. Remove the four mounting screws from the left and right return
guides and remove the guides.
4. Remove the four mounting screws on the right side of the
duplex frame assembly.
5. Position the duplex assembly on its side.
6. Gently release the center drive deflector assembly latch from
the bottom front left side of the duplex assembly.
7. Remove the center drive deflector assembly and the frame
assembly from the duplex unit.
8. Remove the two duplex motor mounting screws and remove the
motor.
Note: Pay attention to cable routing to avoid pinching or cutting
wires during reassembly. Ensure cables are securely placed into the
cable retaining tabs. Adjust the
page 4-2 whenever you remove or replace the duplex motor.
4-20
Service Manual
"Duplex Motor Drive Belts" on