Kyocera KM-4800w User Manual page 36

<Width>
Use file setting : To use the pen width setting decided in the file.
Use custom setting : To use the pen width setting decided by "Custom Setting".
Setting range of "Width" is from 0.04mm to 10.00mm in 0.01mm increment.
Default value is 0.25mm.
<Gray>
Use file setting : To use the gray ratio setting decided in the file.
Use custom setting : To use the gray ratio setting decided by "Custom Setting".
Setting range of "Gray" is from 1% to 100% in 1% increment.
Default value is 100%.
<Custom Setting>
It becomes possible to change "Custom Setting".
At first select some "Pen No.", change "Width" and "Gray" as you like, and then click on "Set".
Your "Width" and "Gray" settings are applied to the selected Pen No.
Width You can decide the width of pen.
Gray You can decide the gray ratio of pen.
Set After changing the above "Width" and "Gray", click on "Set" to apply them to the
selected Pen No.
Default All pen settings are initialized.
<Pen Scale>
The pen width is also enlarged or reduced if output size is enlarged or reduced.
If you do not check it, the pen width is same even if output size is enlarged or reduced.
<Synchronization Setting>
Set a preferable Synchronization by either Automatically Setting or Manual Setting.
Check "Auto Detection" in normal use. You can manually configure "Double Sync", "Checksum",
"Sync-Char" and "End-Char".
<Step Setting>
Change the output size of image by setting of a step number.
Usually, set to 800 for Step Setting.
35