Table of Contents
Advertisement
4 TROUBLESHOOTING
This page presents problems that can be corrected by the user. If a
problem persists even after applying the suggested remedies, contact an
EIZO dealer.
No picture
Problems
1) Indicator status: OFF
2) Indicator status: GREEN
3) Indicator status: YELLOW
(flashing)
4) Indicator status: YELLOW
5) "No signal detected" error
message appears.
• Whenever an error signal message appears, the signal frequency will be displayed
in red.
• Error messages will remain on the screen for 30 seconds, and then disappear. An
error message may not appear at all if the signal frequency is extremely high or
extremely low.
Points to check with possible solutions
Check that the power cord is securely connected.
Try pressing a key on the keyboard, or clicking the
mouse. (The screen-saver software may be active.)
Check brightness and contrast settings. Minimum
settings will cause screen to be blank.
Try pressing the power button. (The off timer
may be active.)
Try pressing a key on the keyboard, or clicking the
mouse. (The screen-saver software may be active.)
If the problem persists, switch off the monitor
main power for a few minutes, then switch it back
on and try again.
Check that the PC is switched ON.
Check that the signal cable is properly connected
to the graphics board or PC.
Check that the graphics board is correctly inserted
in the PC.
Switch the signal input by pushing the input signal
selection button on the front control panel.
For Windows 95/98 users, install the "Monitor
information file" in the utility disk.
4
TROUBLESHOOTING
E
37
Advertisement
Table of Contents
Troubleshooting
