Brother PT-9600 Service Manual page 77

Reassembling the Half Cutter Chassis ASSY
(1) Fit the cutter sensor PCB ASSY to the positioning pins and secure it on the half cutter
chassis ASSY with two screws.
(2) Fit the HC support plate to the positioning pins and secure it on the half cutter chassis ASSY
with two screws.
Half cutter chassis ASSY
Positioning pin
HC support plate
Screws
Fig. 3.2-24 Reassembling the Half Cutter Chassis ASSY (1)
(3) Fit the half cutter chassis ASSY to the positioning pins in two places and secure it on the
chassis ASSY with six screws.
Warning: Take care not to get injured in your fingers with the cutter blade.
Note: Apply the silicon grease (Shin-Etsu Chemical brand G501) by a half rice-grain sized
drop with a brush on "A" portion of control plate.
Take care not to get this
plane stained with grease.
Fig. 3.2-25 Reassembling the Half Cutter Chassis ASSY (2)
Screws
"A"
Chassis ASSY
Positioning pin
Positioning pin
III-43
Cutter sensor PCB ASSY
Screws
Screws
Half cutter chassis ASSY
Positioning pins