Brother PT-9600 Service Manual page 107

(3) Press the "RET" key while the LCD displays as shown in Fig.45. The display shifts to
the Charge Check Mode as shown in Fig.46.
2.14. Charge Check Mode ( " W " key )
This mode checks the charging function.
Note: This mode is used only for PT-9600.
(1) Press the "RET" key. The display shifts to one as shown in Fig.47.
(2) Depression of the "BL" key changes the CHON value to "0". The CHON values can be
changed over by every depression of the "BL" key.
(3) Press the "RET" key while the LCD displays as shown in Fig.47. The display shifts to
the Margin Set Mode as shown in Fig.48.
2.15. Avery Adjust Mode ( " E " key )
This mode sets the correction value of the print start position of avery tape.
Note 1: This mode is used only for PT-9600 and PT-3600 (U.S.A. version).
Note 2: You may skip this submode if the print sample by the Avery Print Mode gets into the
specified zone.
(1) Press the "RET" key. The display shifts to one as shown in Fig.49 and the correction
value currently written in the EEPROM.
(Example: Displays the default value)
Fig. 46
Fig. 47
Fig. 48
Fig. 49
III-73