Installation; Connecting The Monitor To The Pc - Eizo FlexScan F520 User Manual

1 INSTALLATION

1-1. Connecting the monitor to the PC

1) Be sure that the power switches of both the PC and the monitor are OFF.
2) Plug the signal cable into the connector at the rear of the monitor.
• When connecting the signal cable or cable adapter, first check that the shape at
the cable side matches the shape at the connecting side. After connecting,
secure the connection with the screw-in fasteners.
3) Plug the other end of the cable into the video connector on the rear of the PC. Refer
to the figures below.
Standard PC graphics board
• About Plug & Play
When your computer and display support VESA DDC, the suitable resolution
and the refresh rate are set by just plugging your display into the computer
without any manual settings.
Macintosh
An optional Macintosh adapter should be connected to the PC (if required) before
connecting the signal cable. Please consult EIZO dealer.
4) Plug the power cord into the power connector at the rear of the monitor. Then plug
the other end of the cord into a power outlet.
8
1 INSTALLATION
D-Sub
mini 15 pin
D-Sub
mini 15 pin
Signal Cable
(enclosed)
D-Sub
mini 15 pin
mini 15 pin
Signal Cable
(enclosed)
Standard PC graphics board
D-Sub 15 pin
D-Sub
Macintosh
Macintosh Adapter (Optional)