Switching Paper Paths - Oki Pacemark PM4410 Setup Manual

damaging the printhead. Other paper widths must be set
using your software application.
To change the menu setting to 8 inches, turn the printer on,
then:
a. Press
b. Press
c. Press
d. Press
e. Press
f. Press
The Top of Form (TOF) for the rear feed paper path is set at the factory
to 0.35 inch (9 mm) down from the top of the page. If this setting does
not suit your application, you will need to set the Top of Form: see
"Setting Top of Form" in the Front Panel Overview section of this
Setup Guide.

Switching Paper Paths

The Pacemark 4410 is set at the factory for software control of the
paper path. You can enter the menu and change this so that the printer
will automatically switch to the alternate path when paper runs out. To
do this:
1. With the printer turned on, press
2. Press until Set-Up appears on the display.
GROUP
3. Press +
SHIFT
4. Press .
OPTION
Valid will appear on the display.
5. Press .
STORE
An asterisk (*) will appear next to Valid.
6. Press to exit the menu and engage the settings.
MENU
E-30
Untitled-1
.
MENU
until Rear Feed appears on the display.
GROUP
until Page Width appears on the display.
ITEM
once to switch to the 8-inch setting.
OPTION
to save the 8-inch setting.
STORE
to exit the menu mode.
MENU
MENU
until Auto Path appears on the display.
ITEM
30
.
Pacemark 4410 Setup Guide
11/30/98, 1:36 PM