Specifications - Oki ML6300FB User Manual

Specifications

Item
Print method
Print head
Print direction
Print speed
High Speed Draft (HSD)
Letter Quality (LQ)
Utility
Line Feed (LF) time
Form Feed (FF) speed
Paper feed control
Duplication capability
Feeding direction
Feeding mode
Continuous forms tape tail
detection method
Specification
Impact dot matrix
24 pins, 0.2 mm (0.0079 in) diameter
Bi-directional, short-line-seeking
printing
400cps @ 10 cpi
100 cps @ 10 cpi
300 cps @ 10 cpi
Approximately 65 ms per line for LF of
4.23 mm (1/6 in)
Approximately 114.3 mm/s (4.5 in/s)
Paper feed: yes
Vertical tab: yes
Direct line feed: yes
Continuous forms: the original page
+5 more pages (total maximum paper
thickness less than 0.36 mm)
Cut sheet: the original page +5 more
pages (total maximum paper
thickness less than 0.36 mm)
Feed forward
Feed backward
Friction feed mode (front)
Pin tractor feed mode (rear)
Detected when remaining paper is
approximately 24 mm long. It can,
however, print till about 6 mm from
the paper bottom (measured at the
centre of the characters).
(The print accuracy of the last page
cannot be guaranteed.)
Specifications > 64