ViewSonic Pro8600 User Manual page 37

• DCR (Dynamic Contrast Ratio): Enable DCR will further enhance contrast ratio by
darkening the black scenes. Disable DCR will resume to normal contrast
performance. DCR will impact lamp life and system noise performance.
• Message: Enable or disable the message box at the right bottom of the screen.
Function
Allow user to define a short cut key on the remote control, and the function item is selected
in OSD menu.
Test Pattern
Display embedded test pattern.
Quick Power On
• On: The projector will turn on in 3 seconds.
• Off: The projector will turn on following normal power on procedure.
Quick Cooling
• On: The projector will directly shut down without cooling procedure.
• Off: The projector will shut down following normal cooling procedure.
Network
Wired LAN
Allow you to configure the wired LAN settings.
• Status: Display the projector's status.
• DHCP: Abbreviation for Dynamic Host Configuration Protocol. This protocol
automatically assigns IP Address to networked devices.
• When the "DHCP" sets to "On", it takes some time to obtain IP address from
DHCP server.
• When the "DHCP" sets to "Off", that means user will set IP address by manually.
• IP Address: Numerical address to identify networked computers. This function can
only be used when DHCP is set to Off.
• The IP Address is the number that identifies this projector on the network. You
cannot have two devices with the same IP Address on the same network.
• The IP Address "0.0.0.0" is prohibited.
• Subnet Mask: A numeric value to define the number of bits used for a network
address of a divided network (or subnet) in an IP Address. This function can only be
used when DHCP is set to Off.
• The Subnet Mask "0.0.0.0" is prohibited.
• Default Gateway: A server (or router) to communicate across networks (subnets)
that are divided by Subnet Mask. This function can only be used when DHCP is set
to Off.
• DNS: Setup DNS server address when DHCP is disable.
• Apply: Save and execute the wired LAN settings.
Wirless LAN
Allow you to configure the wireless LAN settings.
• Status: Display the projector's status.
• SSID: Display the projector's SSID information.
30