Multicast Vlan Registration Commands; Overview; Chapter 47 Multicast Vlan Registration Commands; Create Multicast Vlan - ZyXEL Communications Dimension GS-4024 User Manual

Multicast VLAN Registration
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.

47.1 Overview

Use the mvr commands in the configuration mode to create and configure multicast VLANs.
Note: If you want to enable IGMP snooping see

47.2 Create Multicast VLAN

Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr <vlan-id>
mvr <vlan-id> source-port <port-list>
mvr <vlan-id> receiver-port <port-list>
mvr <vlan-id> inactive
mvr <vlan-id> mode <dynamic|compatible>
mvr <vlan-id> name <name-str>
mvr <vlan-id> tagged <port-list>
mvr <vlan-id> group <name-str> start-address <ip> end-address <ip>
mvr <vlan-id> exit
where
<vlan-id>
source-port
<port-list>
receiver-port
<port-list>
name <name-str>
mode
<dynamic|compati
ble>

Chapter 47 Multicast VLAN Registration Commands

C
= The VLAN ID [1 – 4094].
= Specifies the MVR source ports which send and receive multicast
traffic.
= Specifies the MVR receiving ports which only receive multicast
traffic.
= A name to identify the multicast VLAN group.
= Specifies dynamic (sends IGMP reports to all source ports in the
multicast VLAN) or compatible (does not send IGMP reports).
GS-4012F/4024 User's Guide
H A P T E R
Commands
Section 44.1 on page
4 7
299.
327