Table of Contents
Advertisement
4. Wired LAN Configurations
Confirming the Operation
Confirm that the projector has connected to the LAN properly.
1. Activate "NetworkModule Client" or "NetworkModule Moderator" which is installed into the
computer connected to the LAN .
2. After appearing "NetworkModule searching" message, the name of the projector* appears
on the Network Projector List, then the network setting has completed properly.
When the name of the projector does not appear and error screen appears, the network has
not connected yet. Try searching again with the Refresh List button. If error screen appears
again, reconfirm the LAN setting. When the projector is set where separated by the router,
see next page.
When Firewall function (Anti-virus software) is effective, network projector may not be found.
In that case, disable the Firewall function and try searching again.
✳ If the projector is named, the name will be displayed. The name can be set with following the
procedures in "6. Configurations with Browser" ➔ "Quick Setup" (pp.44–45) or "Advanced
Setup" ➔ "Miscellaneous" (p.52). If the projector is not named, MAC address of the
projector will be displayed.
NetworkModule Client screen
Refresh List button
28
Network Projector List
Error screen
Advertisement
Table of Contents
