Table of Contents
Advertisement
10. How to Use the PJ Controller
Power & Status
Click "Power & Status" on the main menu and configure each item.
1. Turning on/off the projector
Click Standby/ON buttons. When clicking the Standby button, the confirmation message will
appear. Click OK to turn off the projector.
CAUTION: Projector cannot be turned on for approximately 90 seconds after it being turned off. When
the display of "Power Status" changes from "On cooling down" to " On", click ON to turn on
the projector.
Caution about turning on/off the projector via the networks
When you wish to turn on/off the projector via the networks, preset the projector as follows:
1. Select "Setting" from the Projector menu.
2. Select "Standby mode" from the Setting menu and set it as "Normal".
If you set this function as Normal, the network part of the projector is constantly provided
with power even if the projector is turned off. If you set this as Eco, then the network part
will be turned off when you turn off the projector. Consequently, you cannot turn on/off the
projector via the networks.
78
Advertisement
Table of Contents
