SimpleTech STI-FAX/28.8 User Manual page 28

descriptions. Similarly, the AT commands that affect, or are
related to, the contents of an S-register are listed at the end
of each S-register description.
Refer to Table 5-1 for a summary of the basic AT commands.
Refer to AT Commands for the complete list of AT commands
Command prefix used to begin almost all commands.
AT
Commands preceded by AT and followed by <Enter>
D Dial the following number using the default or
previous method (tone or pulse).
DT Dial the following number using tones.
DP Dial the following number using pulses.
DS=n Dial stored number n.
Wait for dial tone before dialing.
W
H Hang up the phone.
Go on-line (switch from command mode to data
O
mode). Used to resume interrupted communications
when the remote modem is still on-line.
Sr? Read S-register r.
Sr=n Write value n to S-register r.
Zn Reset and recall saved profile n.
&Fn Recall factory configuration n.
&V Display current configuration and stored profiles.
&Wn Save current configuration as profile n.
&Zn=x
Command not preceded by AT and not followed by <Enter>
Repeat the previous command.
A/
16
Table 5-1. AT Command Summary
Save x as stored telephone number n.