Lamp Replacement - Eiki LC-XB21A Owner's Manual

Eiki multimedia projector owner's manual
Table of Contents

Advertisement

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector
draws to an end, the LAMP REPLACE indicator emits
a yellow light. If this indicator lights yellow, replace the
lamp with a new one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow a projector to cool, for at least 45
minutes before you open the Lamp cover.
The inside of the projector can become very
hot.
Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
2
Loosen the screw with a screwdriver, and remove
the lamp cover.
3
Loosen the 3 screws of the lamp with a screwdriver
and lift the lamp out of the projector by using the
built in handles.
Replace the lamp with a new one and secure it
4
with the 3 screws. Make sure that the lamp is set
properly. Replace the lamp cover and tighten the
screw.
5
Connect the AC power cord to the projector and
turn on the projector.
6
Reset the lamp replacement counter .
See "Lamp Replacement Counter" on the next
page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
● Model No. of your projector
● Replacement Lamp Type No.
54
TOP CONTROL
CAUTION
For continued safety, replace with a lamp of
the same type. Do not drop a lamp or touch
a glass bulb! The glass can shatter and
may cause injury.
Lamp Cover
Lamp
Screw
: LC-XB21A
: POA-LMP107
(Service Parts No. 610 330 4564)
T h i s i n d i c a t o r i s
yellow when the life
of the projection lamp
draws to an end.
Screw
Screw
Screw
Handles

Advertisement

Table of Contents
loading

Table of Contents

Save PDF